TheTechGuide Forum

General Category => Software => Topic started by: Brett on September 23, 2004, 05:46:38 PM

Title: BootMagic
Post by: Brett on September 23, 2004, 05:46:38 PM

I used PartitionMagic to install BootMagic in a primary FAT partition on the same drive as Win2k.  The the boot loader seems to work except I get a black screen.  I can get the GUI to load only if I launch PQboot from windows and select the BootMagic partition option and then reboot.  However the next time I boot I get the black screen again (at that point I can time out or hit enter to load windows).  I can't figure out what is cause of this problem.