First of all, excuse me for my english. It's the first time that I found a serious problem with reports using access97. I have design a report that is 56cm wide. I must print it on a HP plotter. When i try to view the report preview or i try to print it directly, access give me the message that it's not possible to print a report that is more of 57cm wide. The same message occures if I reduce the report width of some centimeters. When I have done these tests, the format of the paper was 900mm, that is width of the roll plotter (on his driver); if I change the paper format to A4 or A3, than the message doesn't occures but the print is splitted to 3 pages (that is unusable for my work). Is there a solution of this problem? Or access works only with maximum A3 paper format (instead the report design allow you to use 56cm for making the report) ?
I hope you can help me.
Thank you.
